Oval Config Dozer

Track Sag on Oval configuration Dozers is measured between the front idler and the first Carrier Roller

1 – Place the tape measure or ruler right up against the flange.  2 – Measure to the end of...

1 – Place the depth gauge across the length of the link.  2 – Push the pin through the middle...

This is a count of the number of link in the chain. Commence from the master link moving in a...

1 – Using a temperature gun, hold it between 3-5cm away from the centre of a pin.  2 – Measure...

Grouser rise height is the height of the shoe grouser tip above the ground when:  1 – The machine is...

Check for each major Bogie and count the number of shims included under the bump pads. Record this number in...

Measuring the Link with a Depth Gauge  Measuring Link with an Ultrasonic Probe 

Bush with Callipers  1 – Feel the bush with your hand to see if it has been turned. If it...

1 – Use the tape measure to measure from the start/Middle of the bush on the first link to the...

Shoe with Depth Gauge   1 – Place the depth gauge across two flat shoes from grouser to grouser.  2 –...

Idler with Depth Gauge  1 – Brush idler clean of debris.  2 – Lay depth gauge bar onto flat surface...

Carrier Roller with Callipers 1 – Place callipers at right angle to the carrier roller.  2 – Find the lowest...

Track Roller with Callipers 1 – Place callipers at right angle to the track roller.  2 – Find the lowest...

Measuring the Sprocket with a Ruler  Sprockets wear is measured by measuring the difference between new and used in 3...